![]() Assuming that your receiver is connected to the correct PPM in pin on your flight controller, and it is bound to your radio, it should now work. All you need to do is go to the ‘Configuration Tab’ and scroll down to the ‘Receiver’ section and select PPM RX as the receiver type. PPM ReceiverĬonfiguring a PPM receiver in betaflight is very easy. Once you’ve established what type of receiver you’ve got hooked up to your quad, you can go to the corresponding section below to see how to set it up in betaflight. □ If this is like another language to you, check out our R/C receiver protocols guide! It is important to know this, as the settings are specific to each receiver. For FlySky, it’s likely to be PPM, SBUS or IBUS, and for Specktrum, you will have either DSM2 or DSMX. If you’ve got an FrSky receiver, you’re likely to have either a PPM or SBUS receiver. So, what receiver are you using? You are likely to be using one of the following brands: FrSky, FlySky or Spektrum. We’ve also created several little guides that should help to take you through these processes: Otherwise, none of this will work… If you are unsure how to do this, check out your receiver and/or radio manual. Before following the procedure I’m about to set out, please make sure that your receiver is bound to your radio transmitter, and correctly connected to your flight controller. ![]() Next, we’ll move on to setting up your receiver on your quad.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |